Craftsman C950-52850-0 Owner's Manual page 37

Axle Bearings Axle Bearings
Clutch/Drive Sprocket
Axle
12. Remove the four bolts that hold the bearings on each
side of the hex shaft (see Figure 47).
13. Remove the hex shaft and bearings.
NOTE: Take special note of the position of the
washers on the hex shaft (see Figure 49).
Hex Shaft
Bolts
14. Remove the three fasteners that hold the friction wheel
to the hub (see Figure 48).
15. Remove the friction wheel from the hub. Slip the fric-
tion wheel off the hex shaft.
16. Assemble the new friction wheel onto hub with the fas-
teners removed earlier.
ADJUSTMENT/REPAIR
Axle Support
Bushing
Figure 46
Bearings
Bolts
Figure 47
37
Fasteners
Hex Shaft
17. Install the hex shaft and bearings with the four bolts re-
moved earlier (see Figure 49).
Make sure the washers are properly installed in the
original position. Also, make sure the two washers
are properly aligned with the actuator arms.
18. Make sure the hex shaft turns freely.
Hex Shaft
Actuator Arms
Bearings
Washer
19. To install the remaining parts, reverse the above steps.
20. Check the adjustment of the friction wheel. See "How To
Adjust The Friction Wheel" in this section.
21. Make sure the friction wheel and the disc drive plate are
free from grease or oil.
22. Install the bottom panel (see Figure 37).
23. Tighten the bolts on each side of the bottom panel.
24. Connect the spark plug wire.
Friction
Wheel
Hub
Fasteners Figure 48
Washer
Bearings
Washer
Washer
Figure 49