How To Remove The Snow Hood - Craftsman C950524302A Owner's Manual

ADJUSTMENT/REPAIR
HOW TO REMOVE THE SNOW HOOD
To access the spark plug, the snow hood must be removed
as follows:
1. Remove the choke control knob (see Figure 29).
2. Remove the safety key.
3. Remove the mounting screws (see Figure 30).
4. Slowly remove the snow hood. Make sure that the prim-
er button hose and the ignition wire are not discon-
nected.
5. The spark plug can now be accessed.
6. To installthe snow hood,first make sure that the primer
button hose and the ignitionwire are connected.
7. Mount the snow hood to the engine and secure with the
mounting screws (see Figure 30).
Mounting Screws
Snow Hood
Spark
Plug
Figure 30
8. Connect the choke controlknob with the choke shaft on
the carburetor (see Figure 31 and Figure 32). Make sure
the choke controlknob is properlyinstalled. If the choke
control knob is not installed correctly,the choke will not
operate.
9. Install the safety key.
Choke Control
Knob
Figure 29
Choke Shaft Figure 31
Safety Key
Carburetor
Figure 32
25