HOW TO ASSEMBLE THE DRIFT CUTTER
Drift cutters are used to cut a path through snow deeper than
the auger housing.
1. Loosen the wing nuts that secure the drift cutters to
the auger housing (see Figure 9).
2. Raise the drift cutters to the desired height.
3. Tighten the wing nuts.
CHECK THE TIRES
The tires were over inflated for shipment. Check the tire
pressure in the tires. See the sidewall of the tire for the
proper inflation.
NOTE: This snowthrower was shipped WITH OIL in the engine. See "Before Starting Engine" in-
structions in the OPERATION section of this manual before starting engine.
ASSEMBLY
Wing Nut
IMPORTANT! BEFORE YOU START
OPERATING
Check the fasteners. Make sure all fasteners are
tight.
On electric start models, the unit was shipped with
the starter cord plugged into the engine. Before
operating, unplug the starter cord from the engine.
14
Drift Cutter
Figure 9