Toshiba Diagnostics For The Rs-232 Printer; Toshiba Diagnostics For The Usb Or Rs-485 Printer - Toshiba 1NR Hardware Service Manual

|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|

Toshiba Diagnostics for the RS-232 Printer

|
|
|
|
|
|
|
|
|
|
|
|
|

Toshiba Diagnostics for the USB or RS-485 Printer

|
|
|
|
|
|
|
|
|
42
SureMark Hardware Service
6. Select the option to ADD DEVICE and then choose ADD A
NETWORK PRINTER. Follow the instructions. TGCS Diagnostics will
restart the Diagnostics application and the main Diagnostics screen will
appear again.
7. Navigate to the UTILITIES screen.
8. Printer utilities are visible on this screen as a PRINTER UPDATES
button. Choose PRINTER UPDATES and then select PRINTER
CONFIG.
9. Select MAC ADDRESS CONFIGURATION.
10. Enter the MAC address that you wrote down from the printer's
Ethernet card twice (two different fields). You will be prompted to verify
the MAC address before it is applied to the printer.
Note: The MAC address can only be set one time, so it must be the
correct address for the printer.
11. If there are any other printer activities that must be performed (running
tests, loading firmware, configuring the printer), do them at this time.
12. Shut down TGCS Diagnostics by clicking the SHUTDOWN button on
the top right side of the panel. It is important to shut down, because
this action takes the printer out of Diagnostics Mode when it next
powers on.
The Toshiba Diagnostics package can be used with an RS-232 printer by following
these instructions:
1. Insert the Toshiba Diagnostics memory key into a USB port on the system unit
to which the printer is connected.
2. Boot the laptop with the Diagnostics key inserted.
3. In Toshiba Diagnostics, select either POS I/O Devices or Utilities.
4. Click the ADD DEVICE button at the bottom of the screen.
5. Select ADD A RS-232 PRINTER and follow the instructions.
6. Toshiba Diagnostics will restart the Diagnostics application and display the main
Diagnostics screen again.
7. Perform the necessary Diagnostics activities. When complete, click the
SHUTDOWN button at the top right of the screen.
The Toshiba Diagnostics package can be used with an RS-232 printer by following
these instructions:
1. Insert the Toshiba Diagnostics memory key into a USB port on the system unit
to which the printer is connected.
2. Boot the laptop with the Diagnostics key inserted.
3. In Toshiba Diagnostics, select either POS I/O Devices or Utilities.
4. Perform the necessary Diagnostics activities. When complete, click the
SHUTDOWN button at the top right of the screen.