Http Server Post - Toshiba 1NR Hardware Service Manual

| |
|
|
|
|
|
|
| |
| |
|
|
|
|
|
|
| |
| |
|
|
| |
|
|
|
|
|
|
|
|
|
|

HTTP Server POST

|
|
|
|
|
|
|
|
|
|
|
|
|
Bit 6 Hard Error at the printer (printer offline). MLC error / IFC error /
Firmware can not initialized motion sensor and/or thermal print
head.
Bits 2 - 5
Reserved - should remain high
Bit 0, 1
Version option for returning Trap messages – SNMP manager 1:
11
10
Default: 0xFF
snmptrap2:
Bits 2 - 15
Reserved - should remain high
Bit 0, 1
Version option for returning Trap messages – SNMP manager 2:
11
10
Default:
0xFF
fip: fip: Hex byte
0x03 = User Configured Fixed IP Enabled (default) when there is a
fixed IP defined.
0x02 = Fixed IP Config 1 Enabled
0x01 = Fixed IP Config 2 Enabled
0x00 = Fixed IP Config 3 Enabled
Default:
0xFF
ipv4fixedip
Valid IP address encoded as ASCII encoded Decimal that will return only
when User Configured Fixed IP is enabled and defined.
The HTTP server power-on self-test (POST) is used for updating firmware, sending
the font file, and sending the configuration file.
Firmware Upload:
v The HTTP header starts with upload after POST: POST /upload HTTP/.
v Content type is "multipart/form-data".
v Content-type: String needs to be at the end of header, beginning of data section.
v Response:
– On successful storing: Firmware file download complete.
– On any error with receiving or storing file: Invalid Firmware File.
Configuration Upload:
v The HTTP header starts /upload_Config after POST: POST /upload_Config
HTTP/.
Version 1
Version 2
Version 1
Version 2
Chapter 1. Introducing the 4610 Models 1NR, 1NA, and 1ND
15