Toshiba 1NR Hardware Service Manual page 62

3. Clear the high-order bit and send the value to all printers in the enterprise.
44
SureMark Hardware Service
Table 20. MCT load command settings for low-paper and critically low-paper amounts
Constant
Low-paper amount
Critically low-paper amount
LowPaperCalibrationConstant
Decimal Hexadecimal Description
38 X'26'
39 X'27'
40 X'28'
The amount of paper left in the
printer when it sends the
low-paper status. Default is 5
meters (5000 or 0X'1388';
number is stored as mm).
The amount of paper remaining
in the printer when it sends the
critically low-paper status.
Default is 1 meter (1000 or
0X'03E8'; number is stored as
mm).
The high order bit to this variable
is set after this printer has
calibrated the low-paper amount.
The lower order bits are the
number of mm that the printer
feeds after it detects the sensor
change, until the paper is out.