Chapter 3. Adjusting And Maintaining The 4610; Using And Maintaining The 4610; Replenishing Consumable Supplies - Toshiba 1NR Hardware Service Manual

Chapter 3. Adjusting and maintaining the 4610

|
|

Using and maintaining the 4610

Replenishing consumable supplies

To keep your 4610 Models 1NR, 1NA, and 1ND printers working properly, you
should periodically make printer adjustments and follow recommended maintenance
procedures. This section provides instructions on using, adjusting, and maintaining
your printer, and includes the following topics:
v Replenishing printer supplies
v Cleaning recommendations
For detailed technical information on the 4610 Models 1NR, 1NA, and 1ND printers,
see Chapter 2, "Product specifications," on page 29.
Attention: All covers must be installed on the SureMark 4610 Models 1NR, 1NA,
and 1ND printer before and during operation.
You are responsible for replenishing the supply roll paper.
Loading and replacing the paper roll
Ensure that you have the correct paper for the 4610. See "Supported thermal
paper" on page 36.
1. Press and release the blue release button to release the paper door. In a
wall-mount configuration, you must also pull the door fully open, because of the
brake feature that decelerates it from the full force of gravity.
2. If necessary, remove any unused paper or the empty paper roll core before
inserting a new paper roll.
Note: Refer to the label inside the printer for a diagram of how to load paper.
3. Place the paper roll into the paper roll bucket as shown on the diagram. The
leading edge of the paper should come from the bottom of the roll as shown in
the diagram.
Note: The thermal printhead will not print on paper with glue on it. If the new
paper roll was sealed by glue, tear off the 6 to 8 inches of paper with
glue on it before loading it.
4. Close the paper cover.
5. Press the customer receipt feed button to advance the paper, to verify that the
paper is feeding correctly. Feed 30 cm (about 1 ft) of paper through to test for
correct alignment.
Attention: Do not pull the receipt paper out of the printer with the paper access
cover closed. This disengages the paper feed. The paper feed motor must then
catch up before the printer can feed the paper, which causes missing lines or partial
lines of print. Use the customer receipt feed button to advance the receipt and all
lines will print.
35