Table of Contents
Advertisement
3-5-12.
REPLACEMENT OF THE
MODE SWITCH
1.
Place the deck in the STOP mode.
2.
Remove the Cassette Compartment Unit. (Refer to
Disassembly Procedures).
3.
Remove the Pinch Cam Cap and Pressure Roller
Unit.
4.
Unscrew the 2 screws and remove the Head Amp.
5.
Remove the Pinch Cam.
6.
Unscrew 2 screws (M) and remove the Loading
Motor Base.
7.
Unscrew a screw (N) and unsolder 5 of soldered
portions.
8.
Finally remove the Mode Switch.
MODE
SELECT
SWITCH
SCREWS (M)
Figure M21-A
Figure M21-B
LOADING
MOTOR
BASE
9.
Install a Mode Switch and tighten screw (N), then
solder 5 soldering portions.
10. Install the Pinch Cam and Pressure Roller Unit.
(Refer to "Assembly Procedures of Pinch Cam
&
Pressure Roller Unit.")
11. Install the Loading Motor Base and tighten screw
(M).
12. Install the Head Amp and tighten 2 screws.
13. Install the Cassette Compartment. (Refer to
Reinstallation of Cassette Compartment.)
3-5-13.
REPLACEMENT OF THE
PINCH SOLENOID
1.
Unscrew 2 screws (M) and remove the Loading
Motor Base (Figure M21-A).
2.
Unscrew 2 screws (0), Remove the Motor Pulley
and Loading Motor (Figure M22-A).
3.
Disconnect a connector (red) on the Motor Base
C.BA
4.
Unscrew 2 screws (P)(Figure M22-B) and remove
the Pinch Solenoid.
5.
Install the Pinch Solenoid on to the Motor Base so
that the hole of the Motor Base should be the
large hole of the Solenoid Base (Figure M22-C).
6.
Tighten 2 screws (P).
7.
Install a Loading Motor and tighten 2 screws (0).
8.
Install the Loading Motor Base and tighten 2
screws (M)(Figure M21-A).
LOADING MOTOR BASE UNIT
Figure M22-A
SCREW (P)
CAPSTAN SHAFT
PRESSURE ROLLER UNIT
Figure M22-B
3-14
Advertisement
Chapters
Table of Contents
