Table of Contents
Advertisement
1:2
en
3-7-11.
ASSEMBLY PROCEDURES OF
GEAR BASE UNIT
1. Install the Gear Base Unit and screw 4 screws
(F) as shown in Figure M49.
SCREWS (F)
z
Figure M49
ioe(
.::J:
u
Note: The Gear Base Unit has
2
gears and worm
~
shaft. There is no adjustment for these gears.
3-6-12.
REINSTALLATION OF CASSETTE
COMPARTMENT
When you reinstall the cassette compartment, the
position adjustment of mechanism is necessary for
correct operation, as follows.
A. Confirmation of
STOP
Alignment Condition
1. Turn the Worm shaft counter-clockwise or
clockwise until mechanism is placed into the
Alignment Condition as following conditions.
a) Identification hole on the Mode Select Switch
at 6 oclock position and aligned with small
hole on Pinch Cam. (Figure M48)
b) P5 Arm is completely loading position and
the I nclined Base (S) and (T) are completely
unloading position.
c) Small hole on Sub Cam Gear should align
with small hole on the Connection Gear
(Figure M46) and rectangular mark on the
Connection Gear should be at a 3 oclock
position.
d) Pressure Roller Unit is UP position.
B. Confirmation of Cassette Compartment
1.
Confirm that the Cassette Compartment is
aligned
properly.
In
the
EJECT
position
(Cassette Holder up and advanced to the front)
the two V-shaped marks on the slide switch
should align. The slide switch is located on the
right side of the Cassette Assembly towards the
rear as shown in Figure M50A.
PHOTO TR. <T> C.B.A.
< CASSETTE SWITCH>
Figure M50-A
2. Remove 3 screws (A) as shown in Figure M50-B.
3.
Take the top plate out.
4. Take the cassette Holder unit out as shown in
Figure M50-C.
Figure M50-B
CASSETTE HOLDER UNIT
Figure M50-C Removal of Cassette Holder Unit
3-32
Advertisement
Chapters
Table of Contents
