Table of Contents
Advertisement
3-7-8.
ASSEMBLY PROCEDURES OF
CONNECTION GEAR
Note: Before assembling, Sub Cam Gear position
(and positions of bottom side gears) must be
correct as described before (Figure M39-B).
1. Install the Connection Gear so that the small
hole on the Connection Gear aligns with the
small hole on the Sub Cam Gear as shown in
Figure M46.
SUB CAM GEAR
Figure M46
3-7-9.
ASSEMBLY PROCEDURES OF
MODE SWITCH AND P5 PULL OUT
SECTOR GEAR
1. Turn the Center Gear to unloading position.
2. Install the mode Select Switch and tighten the
mounting screw, then solder the 5 soldering
portions.
3. Install the P5 Pull Out Sector Gear so that the
hole of P5 Pull Out Sector Gear aligns with the
tip of gear at P5 Arm as shown in Figure M47.
<ADJUSTMENT MODE>
UNLOADING POSITION
MODE
SELECT
SWITCH
SOLDERING
PORTION
P5 ARM
Figure M47
3-7-10.
ASSEMBLY PROCEDURES OF
PINCH CAM AND PRESSURE
ROLLER UNIT
1.
Install the Pinch Cam while pushing the P5 post
forward. The gear of the Pinch Cam should drop
to a seated position. In this position make sure
hole in the Mode Select Switch aligns with small
hole on the Pinch Cam, also the small rift on the
Pinch Cam should align with the hole on the
Pinch Speed Down Gear sa shown in Figure
M48.
2. Install the Pressure Roller Unit. Make sure the
seats perfectly onto the Pinch Cam, then install
the Pinch Cam Cap.
PRESSURE
ROLLER UNIT
PROJECTION
HOLES
Figure M48
MODE
SELECT
SWITCH
3-31
~
CIJ
z
«
::z::
()
w
~
Advertisement
Chapters
Table of Contents
