Table of Contents
Advertisement
3-6-12.
HEIGHT ADJUSTMENT OF THE
REEL TABLES
<<TOOL»
Post Adjustment Plate
Reel Table Height Gauge
VFK0191
VFK0190
«SPEC»
O-O.15mm
1 .
Remove the cassette compartment.
2.
Place the post Adjustment Plate on the reel tables.
3.
Place the Reel Table Height Gauge on the plate
so that the scraper of the gauge touches the cut-
out portion of the plate, then set the gauge to zero
o
as shown in Figure M35-A.
Figure M35-A
4.
Measure the height of the top surface of either
Reel table and note the difference in height from
the plate cut-out (Figure M35-A and M35-B).
Repeat this procedures for the other Reel Table.
Figure M35-B
5.
If the difference of Supply Reel table is more than
O.15mm higher or lower, replace the Supply Reel
table. When the difference of Take Up Reel table
is more than O.15mm higher or lower, adjust nut
(A)(Figure M35-C) so that measurement becomes
the spec. If you can not adjust to the spec.,
replace Take Up Reel table.
NUT (A)
r---L----~____,
TAKE-UP
REEL TABLE
Figure M35-C
Note:
When replacing the tables, the DD Reel Unit
needs to be removed from the chassis.
Remove 6 screws and carefully lift it out as
shown in Figure M35-D.
SCREWS (L)
CONNECTOR
Figure M35-D Bottom View of DD Reel Unit
Note:
When assembling the DD Reel Unit, slide a
Main Rod to far left side by rotating the
Center Gear, and then screw the 6 screws.
MAIN ROD
~
CUT WASHERS
Figure M35-E
3-25
:2
(/')
z
«
J:
()
w
:2
Advertisement
Chapters
Table of Contents
