Table of Contents
Advertisement
V1IVO~O.7
V2IVO~O.8
V3IVO~O.7
V1
V2
V3
VO
Figure M26-E
3-6-4. ADJUSTMENT OF THE PULL-OUT
POST (PS) HEIGHT
«TOOL»
Post Adjustment
Reel Table Height Gauge
Nut Driver
«SPEC»
0.03mm
±
0.01 mm
VFK0191
VFK0190
Purchase locally
Note:
Unless the replacement or adjustment this
post is required, the adjustment nut should
not be turned.
1.
Remove the cassette compartment (Refer to
Disassembly procedures).
2.
Place the Post Adjustment Plate over the reel
tables.
3.
Turn the Worm Shaft counterclockwise (loading
direction) until the mechanical condition becomes
as shown in Figure M27-A.
Figure M27-A
4.
Place the Reel Table Height Gauge on the Post
Adjustment Plate and set the gauge to zero 0 as
shown in Figure M27-B.
HEIGHT GAUGE
SET HEIGHT
GAUGE TO ·0·
VFK0191
(
ot
"
l
Figure M27-B
5. P!ace the Reel Table Height Gauge as shown in
Figure M27-C and turn the nut slowly until the
gauge reads.
HEIGHT GAUGE
P LL OUT POST
Figure M27-C
6.
After
the
adjustment,
install
the
cassette
compartment (Refer to reinstallation of Cassette
Compartment) .
7.
Play back a normal cassette tape on Review
search mode, and make sure that the edges of the
tape are not curling or waving at the bottom end of
the P4 post by using the Check Light as shown in
Figure M27-D.
P4 POST
NO WAVING OR FRILLlNG
Figure M27-D
Note:
There is easy method to check Waving of
Filling. If there is Waving or Filling in the
lower edge, the white black pattern which is
reflected on the tape will curve or not linear
as shown in Figure M27-E.
3-19
:2
en
z
«
::z::
()
w
:2
Advertisement
Chapters
Table of Contents
