Table of Contents
Advertisement
:2!
Cl)
z
«
:::I:
()
w
:E
3-7-5.
ASSEMBLY PROCEDURES OF
CENTER GEAR
1. Softly Install the Center Gear onto the Retainer
Gear so that the two holes in the Center Gear
align with the holes on the Retainer Gear, then
install the cut washer as shown in Figure M43.
CAPSTAN
MOTOR
CENTER GEAR
LOADING CAM
GEAR
THROUGHT HOLE
I
CENTER GEAR
WZl ~.r'
WZl,~-
RETAINER GEAR
~RING
GEAR
CHASSIS
Figure M43
3-7-6.
ASSEMBLY PROCEDURES OF
MAIN LEVER AND CAM
FOLLOWER ARM UNIT
1.
Install the Main Rod and then insert the cut
washers as shown in Figure M44.
2. Install the Cam Follower Arm so that the pin of
the Cam Follower Arm inserts into the groove of
the Main Cam Gear and also inserts into the slot
on the Main Rod, insert the retaining ring.
CUT WASHERS
Figure M44
3-7-7.
ASSEMBLY PROCEDURES OF
LOADING GEAR
(T),
LOADING
GEAR (S) SECTOR GEAR
1. Set the P2 and P3 posts to fully unloaded
position, then install the Loading Gear
(T)
and
(S) so that the outer hole on the Loading Gear
(T)
aligns with the outer hole on the Loading
Gear (S) as shown in Figure M45-A.
2. Install the Sector Gear so that the outer hole in
the Sector Gear aligns with the projection mark
on Loading Gear
(T).
3. Insert 3 retaining rings as shown in Figure M45-
B.
SECTOR GEAR
LOADING GEAR (T)
LOADING GEAR (S)
Figure M45-A
RETAINING
r
RINGS
RETAINING~
RINGS
I
SECTOR GEAR
Figure M45-B
3-30
Advertisement
Chapters
Table of Contents
