Table of Contents
Advertisement
3-5-5. REPLACEMENT OF THE
CAPSTAN ROTOR AND
CAPSTAN STATOR
When replacing the Capstan stator unit the centre
Fixing Tool must be used to fix the centre of Capstan
Stator Unit.
1.
Remove the loading belt.
2.
Unscrew the 4 (F) screws and remove the Gear
base Unit.
3.
Carefully lift up the capstan rotor from the capstan
housing, taking care so as not loose the 2 oil seals
as shown in Figure M14-A.
SCREWS (F)
GEAR BASE UNIT
Figure
M14-A
4.
Remove the 2 oil seals.
5.
Unscrew the 3 (G) screws and remove the
Capstan Stator.
6.
Place the capstan stator unit into position.
7.
Loosely tighten the 3 (G) screws.
8.
Insert the Centre Fixing Tool as shown in Figure
M14-B.
CENTER FOXOMG TOOL (VFK0951)
l
LOWER METAL
UPPER METAL
Figure
M14-B
3 -11
STATOR UNIT
Figure
M14-C
9.
Tighten the 3 (G) screws.
10. Remove the centre fixing tool.
11. The new capstan rotor unit can be reinstalled by
reversing the removal procedure.
3-5-6. REPLACEMENT OF THE
CAPSTAN HOUSING UNIT
1.
Remove the pressure Roller Unit.
2.
Remove the Sub post spring from hook of Capstan
Housing.
3.
Unscrew the 3 screws (H) and remove the
Capstan Housing.
4.
Remove the 2 oil seals and thrust screw.
SCREWS(H)
~
THRUST SCREW
ye
a
OIL SEALS
f--
SUB POST SPRING
Figure
M15
5.
Replace the new Capstan Housing, 2 oil seals and
thrust screw at same time.
6.
Re-install the Capstan Housing Unit by reversing
the remove procedure.
Note:
After re-installing the thrust screw adjustment
of the thrust screw are required.
Replace the new Capstan Rotor, 2 oil seals
and thrust screw at same time.
After re-installing the capstan rotor or capstan
stator confirmation of FG out put level and
adjustment of FG head gap are required.
~
Cl)
z
<C
J:
U
w
~
Advertisement
Chapters
Table of Contents
