Radiodetection SuperCAT 4+ User Manual page 3

ALWAYS DIG WITH CAUTION
Risk of property damage, death, or serious injury may
result if buried pipes and cables are not properly located
before digging.
Read and follow all instructions and warnings in this user
guide before using the SuperCAT4+ and T1 transmitter.
Regularly check your SuperCAT4+ and T1 transmitter,
in all modes, over a cable which gives a response you are
familiar with.
Some power cables DO NOT radiate detectable power
signals.
Power and Radio signals may not be present. It is
advisable to use the T1 transmitter whenever searching for
pipes and cables.
Do not use the SuperCAT4+ depth estimation function
to decide if mechanical digging over a buried conductor is
appropriate.
StrikeAlert ™ may not activate even if a live power cable
is present.
The presence of 'StrikeAlert Activated' label does not
guarantee that this feature is activated.
Keep mobile phones away from cable and pipe locators
when in operation. Minimum distance 60cm/24" recommended.
The SuperCAT4+ cannot indicate whether a signal comes
from a single conductor or from several cables or pipes
bundled or buried in close proximity to each other.
It is recommended that the SuperCAT4+ and T1
transmitter are serviced at least once a year and have their
calibration validated using Radiodetection approved test
equipment. Radiodetection will accept no responsibility for
repairs carried out by unauthorized repairers.
Even if using a SuperCAT4+ and T1 transmitter, ALWAYS
DIG WITH CAUTION.
Call your local support number (available from: www.radiodetection.com)
for questions regarding the proper use, maintenance, and repair of the
SuperCAT4+ and T1 transmitter.
4
SuperCAT4 range
Modes / features
StrikeAlert
Depth
Sonde 512 / 640 Hz*
Sonde MF 8 kHz
Sonde HF 33 kHz
Active Line 512 / 640 Hz*
Active Line 8 kHz
Active Line 33 kHz
Active Line 65 kHz
Super HF 131 kHz
CPS**
Radio
Power 50 Hz / 60 Hz*
*Set by power frequency: 50 / 640 Hz or 60 / 512 Hz
**Set by power frequency: 50 / 100 Hz or 60 / 120 Hz
T1 transmitter range
512
Induction 8 kHz
✔
Induction 33 kHz
✔
Induction 65 kHz
Direct Connect 512 Hz
✔
Direct Connect 640 Hz
Direct Connect 8 kHz
✔
Direct Connect 33 kHz
✔
Direct Connect 65 kHz
Direct Connect 131 kHz
+ S CPSS
✔ ✔ ✔
✔ ✔ ✔
✔ ✔
✔
✔ ✔
✔ ✔
✔ ✔
✔ ✔ ✔
✔
✔
✔
✔ ✔ ✔
✔ ✔ ✔
640 512/65 640/65 131
✔ ✔ ✔ ✔
✔ ✔
✔ ✔
✔
✔ ✔
✔ ✔ ✔ ✔
✔ ✔
✔ ✔
✔
5