Section 1 - Preface energized lines. Before you begin Thank you for your interest in Radiodetection’s RD8200 ® WARNING! The transmitter is capable of outputting cable and pipe locator. potentially lethal voltages. Take care when applying signals The RD8200 delivers the latest in locating technology in to any pipe or cable and be sure to notify other technicians a powerful yet ergonomic and light-weight design.
WARNING! Only use charging equipment provided by Bluetooth antenna and your body. The location of the Radiodetection. The use of alternative chargers may cause antenna is shown in Section 3, figure 3.1. a safety hazard and/or reduce the life of the battery.
From time to time Radiodetection may release new software to improve the performance or add new government for more information. functionality to products. By registering the user will have...
Page 16
Charging the battery packs WARNING! Only use charging equipment provided by Radiodetection. The use of alternative chargers may cause a safety hazard and/or reduce the life of the battery. CAUTION: Do not let your battery completely discharge as this may reduce its life or damage it permanently. If you are not using your equipment for a long period charge them at least once a month.
For more information on the theory of cable and pipe location, refer to The theory of buried cable and pipe location which is available to download from www.radiodetection.com Contact your local Radiodetection sales office or 5.1 Frequencies distributor if you require help in identifying these operators.
1. On your Android device open Google’s Play Store Press the key to enter the iLOC menu 2. Search for RD Map by Radiodetection Ltd Re-pair your devices as described in section 10.2 3. Install the app Bluetooth error codes Refer to the RD Map operation manual for more info on how to retrieve stored survey measurements.
Point the screen of the locator towards the transmitter If you experience problems with the RD8200 wireless iLOC technology features, Radiodetection recommends resetting the connection and then pairing your device again. To reset the wireless iLOC connections: Press the...
RD8200 locator. the screen. Place the clamp around the pipe or cable and switch Radiodetection supply an accessory sheet with pictures the locator on. and details of all applicable accessories which is available on www.radiodetection.com Set the frequency to the same as that on the transmitter.
Page 49
Reduce the locator sensitivity to lose the ghost signals but still Radiodetection offers a wide range of sonde to suit most indicate a clear Peak response directly over the sonde. applications: From the ¼” / 6 mm diameter S6 33kHz Locator sensitivity is now set for tracing the duct or drain microsonde which, with a range of 6.6”...
The FlexiTrace has a maximum power rating of 1W. placed firmly against the cable to be identified. If there When using the FlexiTrace with a Radiodetection Tx-5 are a number of cables, the stethoscope antenna will or Tx-10 transmitter the output limit must be set to 1W in...
Batteries and power supply 13.2 Enhanced Self-Test Use good quality Alkaline or NiMH batteries only. When using an AC adapter, use only Radiodetection RD8200 locators incorporate an Enhanced Self-Test approved adapters. feature. In addition to the typical checks for display and power functions, the RD8200 applies test signals to its Only use Radiodetection approved Li-Ion battery packs.
In the unlikely event of an issue with this clock the From time to time Radiodetection may release new system will emit a warning audio tone and display the software to improve the performance or add new word ERROR, followed by a 3 digit error code.