Replacing Batteries; Product Specification - Radiodetection SuperCAT 4+ User Manual

Replacing batteries

Do not mix new and old batteries or different types of
batteries, as this may cause them to overheat.
SuperCAT4+
To replace batteries, open the access cover using
a screwdriver or coin. Use two LR20 (D-cell)
alkaline batteries or equivalent NiMH rechargeable
batteries.
T1
To replace batteries, Unscrew fastener on the rear
panel and replace with four LR20 (D cells) alkaline
batteries. Observe correct battery polarity as indicated
on the top-panel label.
18

Product specification

Locator Technical Specification
Locate Frequency
performance range
Power signals 50 Hz – 1.5 kHz
(P)
Radio signals 15 kHz – 30 kHz
(R)
T1 signals (L) 512/640 Hz
1
8 kHz
33 kHz
65 kHz
131 kHz
Sonde (S) 512 Hz / 640 Hz /
1
8 kHz / 33 kHz
1
Model dependent
Dynamic range 120 dB @ 10 Hz
Dynamic Overload Protection 40 dB @ 50 Hz (automatic)
Locate accuracy ± 10% of depth
Depth accuracy (on undistorted Line: 5% 0.1 m to 3 m (4 in to 10 ft)
signal and with no adjacent
Sonde: 5% 0.1 m to 7 m (4 in to 16 ft)
signals)
Operating temperature range -20°C to +50°C (4°F to 122°F)
Storage temperature range -20°C to 70°C (4°F to 158°F)
Environmental protection IP54
Batteries Locator:
2 x Alkaline or NiMH D-cells (LR20)
Transmitter T1:
4 x Alkaline D-cells (LR20)
Data interface USB 2.0 – for future use
Recommended service interval 1 year
12 months from purchase
Warranty
Unit Weight Locator:
2.3 kg (5.1 lbs) (including batteries)
Transmitter:
1.7 kg (3,8 lbs) (including batteries)
Sensitivity Depth Depth
@ 1m Good Poor
conditions conditions
3 mA 3 m 2 m
2 m
25 μA 1 m
4 m
500 μA 2 m
100 μA
5 μA
5 μA
5 μA
N/A Up to 15 m
19