Table of Contents
Advertisement
1. Align front HDD with the anchor point on the tray and slide in HDD at an angle.
2. Push down HDD carefully.
NOTE:
To ensure proper system air flow requirements, all front drive bays must be populated with a drive carrier. Drive carriers
must be installed with either a drive or supplied drive blank.
There are drive carriers to support 2.5" devices and 3.5" devices. To maintain system thermals, all drive bays must be populated with
a drive carrier mounted with a hard disk drive, SSD, or supplied drive blank. Drive blanks used with the 3.5" drive carrier can also be
used to mount a 2.5" SSD into it as shown below.
1. Align front HDD with the anchor point on the tray.
2. Assemble 2.5" HDD with tray by 4 screws on the side of tray.
Figure 24 2.5'' HDD Installation (Tool-less)
Figure 25 2.5" HDD Installation (Screw)
RM133 Series
/ Installation
25
│
Advertisement
Table of Contents
