S13 - Remote Programming Mf4 Send Rate; S15 - Digit Recognition On Outgoing Calls; S16 - Digit Recognition On Incoming Calls - Mitel SmarT-1 EuroRoute Installation & Programming Manual

Line and Trunk Options

8. 15. S13 - Remote Programming MF4 Send Rate

This register defines the on/off time of MF4 tones sent by the EuroRoute during tandem or
remote programming.
Port Register
1 113 T
2 213 T
3 313 T
4 413 T
To change all Ports to the same value use 513 T.
Note: If you are using a terminal you can substitute the letter A for

8. 16. S15 - Digit Recognition on Outgoing Calls

This register controls the treatment of digits detected during an outgoing call.
Port Register
1 115 T
2 215 T
3 315 T
4 415 T
To change all Ports to the same value use 515 T.
† NU Tone = Number Unobtainable Tone.
Note: If S15 = 2 or 6, MF4 programming will not be allowed.

8. 17. S16 - Digit Recognition on Incoming Calls

This register controls the treatment of digits detected during an incoming call.
Port Register
1 116 T
2 216 T
3 316 T
4 416 T
To change all Ports to the same value use 516 T.
55
Default
9 T = 3 For 70 ms
9 T = 4 For 80 ms
9 T = 5 For 90 ms
9 T = 6 For 100 ms
T = 7 For 110 ms
T = 8 For 120 ms
T = 9 For 130 ms
Default
0 T = 0 For MF4 or Rotary Allowed
0 T = 1 For Ignore all Rotary
0 T = 2 For Ignore MF4
0 T = 3 For Ignore all Digits
T = 5 For NU Tone on Rotary †
T = 6 For NU Tone on MF4 †
T = 7 For NU Tone on Any Dialled Digit †
Default
0 T = 0 For Allow MF4 or Rotary
0 T = 1 For Ignore All Rotary
0 T = 2 For Ignore All MF4
0 T = 3 For Ignore All Dialled Digits
Description
T = For 140 ms
T = # For 150 ms
T = C For 160 ms
T = D For 170 ms
T = E For 180 ms
T = F For 190 ms
and B for #.
Description
Description
8350-383-113-BA
Draft 1A, September 1998