Table of Contents
Advertisement
Appendix B: Programming an R2 Trunk
22.
Open a web browser (recommended Mozilla Firefox and Google Chrome), and type
the IP address (specified in step 15 (a)) in the address bar, and press Enter.
The EX Controller Deployment Tool home page is displayed.
23.
Continue with
8 Appendix B: Programming an R2 Trunk
Programming an R2 trunk
The Channel Associated Signaling (CAS) is a method of signaling where each traffic
channel has a dedicated signaling channel. The signaling for a particular traffic circuit
is permanently associated with that circuit. The EX Controller unit uses the R2 CAS
protocol. This is a compelled sequence multi-frequency code signaling. In R2 signaling,
the equipment units at the exchanges that send and receive digits, and the signaling
between these units are usually referred to as register and inter-register signaling.
To program an R2 trunk on an EX Controller:
1.
Log in to the EX Controller Web GUI with user name admin and enter the password
that you use for logging in to the Server Manager. For more information about how
to log in to EX Controller Web GUI, see
44.
2.
Navigate to the System > Hardware tab.
3.
Scroll down to the PRI Ports Configuration section.
87
Updating the EX Controller Deployment Tool
on page 30.
Log into the EX Controller Web GUI
EX Controller Installation and Administration Guide
on page
Advertisement
Table of Contents
