Chapter 4; Initialisation - Mitel SmarT-1 EuroRoute Installation & Programming Manual

4. Initialisation

Before you can program the EuroRoute for the first time, you must initialise the unit.
Initialisation can only be done by using an MF4 telephone.
4. 1. Initialisation
1. Connect an MF4 instrument to the subscriber side of the block (A and B leads of the
EuroRoute).
Caution: Do not open the EuroRoute, as this will void the warranty.
2. With the power to the EuroRoute disconnected, go off-hook. While holding down the
key on the MF4 set, you will hear a continuous tone (if no continuous tone is heard, you
must obtain an MF4 set that will provide the continuous tone). Connect the power to the
EuroRoute. When the power is first applied, there is a "click" sound heard from the
EuroRoute as it disconnects you from the Exchange line side.
3. Continue to hold down the
EuroRoute (See Note).
Note: When you press the
programming using the #0 sequence) and if you hear NU tone from the exchange line, or
customer equipment, the telephone may be on the wrong side of the telephone block.
Check your connections, see Figure 3.7 on page 24.
8350-383-113-BA
Draft 1A, September 1998

CHAPTER 4

Figure 4.10 EuroRoute Initialisation
key for 15 to 20 seconds, after applying power to the
key on the telephone (connected to the EuroRoute for
Initialisation
28