Mitel SmarT-1 EuroRoute Installation & Programming Manual page 100

Chaining
7. Each Chaining Cable has one Male RJ -11 Connector, one Female RJ -11 Connector, and
one Male DB 9 RS-232 Serial Connector (See Diagram Below).
Note: This chaining cable cannot be used as an optional printer cable to install a recording
device.
8. Connect the Plastic Plug from the First Dialer into the Plastic Jack of the Second Dialer,
then connect the Plastic Plug of the Second Dialer into the Plastic Jack of the Third Dialer,
then connect the Plastic Plug of the Third Dialer into the Plastic Jack of the First Dialer.
(See Figure 15.18).
FIRST DIALER
9. Reconnect the Power to Each Dialer.
Note: The Dialers should be powered up sequentially, beginning with Dialer 1.
10. Enter program mode on Dialer # 1 by entering #0 (Default).
11. Enter 950, you hear ee.
If you hear eeee, Chaining has failed. Repeat all steps to attempt the Chaining process
again.
99
Figure 15.17 Chaining Cable
Figure 15.18 Chaining Illustration
SECOND DIALER THIRD DIALER
8350-383-113-BA
Draft 1A, September 1998