Program Mode Exit; Remote Access Security Code; Programming Security Code Defaults - Mitel SmarT-1 EuroRoute Installation & Programming Manual

Security Access Registers
The third stage starts with the EuroRoute sending an MF4 "D" to the remote point. The
EuroRoute restarts the Auto-answer Wait for Security Code Timer and waits for MF4 digits to
match the contents of 691 Register or the 695 Register. If there is a match on the first attempt,
the EuroRoute sends an MF4 "A" to the remote point and enters programming mode with the
Remote indicator set. If there is no match within the time specified by the S34 Register, or if
the code is not entered correctly, the line goes to the answer lockout state for a period of time
defined by the S35 Register.

5. 4. Program Mode Exit

When a remote programming session ends, exit programming mode by entering 987.

5. 5. 604 - Remote Access Security Code

Register
This code must be matched after manual answer or auto
604 answer to allow remote programming access. This register
may contain up to 80 digits.
Example: 604#1 ##

5. 6. Programming Security Code Defaults

Each of the following security codes can be entered via the Hexadecimal chart found on
page 118 or by entering the exact code to be used. Consult the following table for the default
entries.
Register
690 Installer Terminal Access
691 Installer MF4 Access
695 Abbreviated Dial MF4 Access
† Note: The Default values in the 690 register is entered in Hexadecimal format.
†† Note: The Default values in the 691, and 695 registers are entered in MF4 format.
31
Description
Programming Security Code Defaults
Description
Default
#1
Value Entered in
EuroRoute ASCII or MF4
(Default) Value
23302A † #0
#0 †† #0
#2 †† #2
8350-383-113-BA
Draft 1A, September 1998