Mitel SmarT-1 EuroRoute Installation & Programming Manual page 24

Basic Hardware Installation
If the EuroRoute has the bracket assembly shown in Figure 3.5, the assemblies should be
carefully pried off with a screwdriver, as shown in Figure 3.5.
Remove the rubber feet from the top of the EuroRoute base, as shown in Figure 3.6; leave the
two lower rubber feet intact. Insert the plastic push rivets through the right angle mounting
bracket until the EuroRoute is flush with the bracket.
23
Figure 3.5 Mounting Bracket Removal
Figure 3.6 Right Angle Wall Mounting
8350-383-113-BA
Draft 1A, September 1998