Mitel SmarT-1 EuroRoute Installation & Programming Manual page 30

Initialisation
key. The EuroRoute should respond immediately with a short e. You may
4. Release the
hear two short tones (ee) depending on the previous condition of the EuroRoute. If a
single or double tone is not heard, return to Step 2, and restart. The tone bursts indicate that
the EuroRoute is initialised and remains in programming mode. Dial 942 and ee is heard.
Dial 903 and ee is heard, indicating that the default data has been loaded, and that the
EuroRoute is still in the programming mode.
Idling in programming mode for more than two minutes results in an automatic exiting of
programming mode. eee is heard after 60 seconds, if there is no activity in programming
mode.
5. To exit programming mode and save changes made while in programming mode, dial 987.
Do not disconnect the power from the EuroRoute while the green LED is flashing after
exiting programming mode. During this period, any programming in the EuroRoute is
being stored into the EuroRoute's non-volatile memory. Disconnecting the power
prematurely will result in a loss of programming and probably a checksum error.
29
8350-383-113-BA
Draft 1A, September 1998