Shimano Alfine S7000 Series Dealer's Manual page 37

MAINTENANCE
Replacement and assembly of the indicator unit
Installation
(A)
(B)
1
(C)
2
Operate the main and the release levers, to check their operation.
3
If they do not operate correctly, reinstall the indicator unit while taking particular note of
step 1.
Check that the needle of the indicator is
on the left side ( 8 position), and then
install the indicator unit so that it is
facing straight upward.
Insert the pin of the change plate that is
protruding from the bottom of the
(D)
indicator unit into the hole in the winder
unit at this time.
Secure the indicator unit with the two
(A)
cover fixing screws.
37
(A)
Indicator unit
(B)
Pin of change plate
(C)
Hole in winder unit ( 8 position)
(D)
Release lever
(A)
Cover fixing screws
Tightening torque
0.3 - 0.5 N·m