Shimano Alfine S7000 Series Dealer's Manual page 26

INSTALLATION
Installation of the shifting cable
Cassette joint end
1
(A)
(D)
2
(E)
(A)
To be continued on next page
Install the rubber cover and rubber
bellows to the outer casing holder unit.
(B) (C)
Wipe away any grease which may be on
(E)
the inner cable and, while holding the
end of the rubber bellows, pass the inner
cable through. Be careful not to pierce
the rubber bellows with the end of the
inner cable at this time.
Slide the rubber bellows onto the inner
cable.
(B) (F)
After this, insert the outer casing into
the rubber cover and set it into the outer
casing holder unit. Push the outer casing
so that it securely touches the holder
(C)
unit.
26
(A)
Rubber bellows
(B)
Outer casing holder unit
(C)
Rubber cover
(A)
Rubber bellows
(B)
Outer casing holder unit
(C)
Rubber cover
(D)
End of rubber bellows
(E)
Inner cable
(F)
Outer casing
NOTE
Use a new inner cable. Do not use a cable
which has had the end cut off.
Pay attention to the end of the inner cable.