Shimano Alfine S7000 Series Dealer's Manual page 25

INSTALLATION
Installation of the shifting cable
(A)
5
(B)
(A)
6
Screw in the wire end hooking cap as
shown in the illustration until it stops.
If it is turned any further, it will damage
the screw thread in the cover.
In addition, the unit cover may become
bent, which may cause an obstruction
between the unit cover and the main
lever, and the main lever may not
operate correctly.
If the main lever does not return
(C)
properly, loosen the wire end hooking
cap slightly to make a gap between the
main lever and the unit cover, and check
that this improves the returning of the
main lever.
Pass the inner cable through the
(z)
OT-SP41/ SP40 outer casing through the
end with the plastic cap.
(z)
(B)
Lever side
25
(A)
Wire end hooking cap
(B)
Unit cover
(C)
Main lever
Tightening torque
0.3 - 0.5 N·m
(A)
Aluminum cap
(B)
Plastic cap
TECH TIPS
If cutting the outer casing, cut it near the end
with the plastic cap while the cap is still
attached.
Then make the cut end perfectly round and
attach the plastic cap.
Plastic cap
Remove the plastic cap
Make the cut end perfectly round.
Attach the plastic cap