Data Bits; Stop Bits; Protection Of Data Set-Up Using Password - Circutor CVM-MINI SERIES Instruction Manual

4.2.5 Data bits

7 or 8 data bits may be selected; to select the number of bits, press the
and the two options will alternate in turn. Once the required option is selected,
press the key to enter the data and access the next setting step.

4.2.6 Stop bits

1 or 2 stop bits may be selected; to select the number of bits, press the
and the two options will alternate in turn. Once the required option is selected,
press the key to enter the data and access the next setting step.

4.2.7 Protection of data Set-up using password

This menu option aims to protect the data set in Measurement Set-up.
As a default the equipment does NOT protect data with the "unlo" option. By
pressing the
If, on the other hand, the parameters in Measurement Set-up are to be protected,
the option "Loc" has to be selected using the
pressed. The protection password as a default will always be 1234; any other
password code entered will be incorrect.
s e t
p a s s
0 0 0 0
Figure 60. Password request to
protect Set-up data
For entering the password, repeatedly press the
the digit which is flashing at the time.
s e t
Pa r i
n o
Figure 57. Parity
Figure 58. Data bits
s e t
s t o p
Figure 59. Stop bits
key the data is entered and setting the equipment is finalised.
Page 21 of 26
1
key and then the
max
s e t
p a s s
1 2 3 4
Figure 61. Enter password to protect
Set-up data
key increasing the value of
max
key
max
key
max
key