Typical Connection Of The Triac Outputs 1 Through 4; Typical Connection Of Output #5; Figure 10 - Conection Of Outputs 3 And 4; Figure 11 - Connecting The Analog Output (External Power) - Prolon C1000 Series Hardware Manual

Typical Connection of the Triac Outputs 1 through 4

On the C1000 Rooftop controller, all triac outputs must be set to SOURCE mode because they all share a
single source supply: the equipment's transformer. All triac outputs have a SOURCE / SINK configuration
switch; they must be set to "SWITCH" (move switch towards terminal blocks). Only the terminal blocks
marked 24 VAC are used for each output (see Figure 10).

Typical Connection of Output #5

Output 5 is an analog output 0-10 VDC. It can be configured to modulate a 0 to 10 VDC load, to pulse a 0
or 10 VDC Triac relay or to control a 10 VDC On/Off relay (see Figure 11).
REV. 6.1.6 / PL-HRDW-RTU-C1000-C/F-EN

Figure 10 - Conection of Outputs 3 and 4

Figure 11 - Connecting the Analog Output (External Power)

Equipment Terminal Board
(W1)
(Y2)
External Load
(+)
SSR
(-)
12