Table of Contents
Advertisement
Introduction
1 Introduction
1.1.1 About this Manual
First time users can obtain the most essential information
for quick installation and set-up in these chapters:
1 Introduction
2 How to Install
3 How to Configure
For more detailed information, including the full range of
set-up options and diagnosis tools, refer to the chapters:
4 Configure the Master
5 How to Control the Frequency Converter
7 Parameters
8 Application Examples
9 Troubleshooting
Terminology
In this manual the term Ethernet is used to describe the
physical layer of the network and does not relate to the
application protocol.
1.1.2 Assumptions
These operating instructions are under the conditions that
the Danfoss POWERLINK option is used with a Danfoss
®
VLT
AutomationDrive FC 301/FC 302 frequency converter.
The installed controller must support the interfaces
described in this document. Strictly observe all the
requirements stipulated in the controller and the frequency
converter, along with all limitations herein.
1.1.3 Hardware
This manual relates to the POWERLINK option MCA 123,
type no. 130B5546 (uncoated) and 130B5646 (conformal
coated).
1.1.4 Background Knowledge
The Danfoss POWERLINK Option Card is designed to
communicate with any system complying with the
POWERLINK standard. Familiarity with this technology is
assumed. Issues regarding hardware or software produced
by other manufacturers, including commissioning tools, are
MCA 123 POWERLINK Operating Instructions
beyond the scope of this manual, and not the responsi-
bility of Danfoss.
For information regarding commissioning tools, or
communication to a non-Danfoss node, consult the
appropriate manuals.
1.1.5 Available Literature
Available Literature for FC 301/FC 302
Danfoss technical literature is also available online at
http://www.danfoss.com/BusinessAreas/DrivesSolutions/
®
MG92C102 - VLT
is a registered Danfoss trademark
-
®
The VLT
AutomationDrive Operating Instructions
provide the necessary information for getting the
frequency converter up and running.
®
-
The VLT
AutomationDrive Design Guide entails all
technical information about the frequency
converter design and applications including
encoder, resolver, and relay options.
®
-
The VLT
AutomationDrive Profibus Operating
Instructions provide the information required for
controlling, monitoring, and programming the
frequency converter via a Profibus fieldbus.
-
®
The VLT
AutomationDrive DeviceNet Operating
Instructions provide the information required for
controlling, monitoring, and programming the
frequency converter via a DeviceNet fieldbus.
®
-
The VLT
AutomationDrive MCT 10 Set-up Software
Operating Instructions provide information for
installation and use of the software on a PC.
®
-
The VLT
AutomationDrive IP21/Type 1 Instruction
provides information for installing the IP21/Type
1 option.
®
-
The VLT
AutomationDrive 24 V DC Backup
Instruction provides information for installing the
24 V DC Backup option.
-
®
The VLT
AutomationDrive CanOpen Operating
Instructions.
®
-
The VLT
AutomationDrive Modbus TCP Operating
Instructions.
-
The MCA 121 EtherNet/IP Operating Instructions.
-
The MCA 120 PROFINET Operation Instructions.
-
The MCA 124 EtherCAT Operation Instructions.
-
The MCA 123 Modbus TCP Operation Instructions.
1
1
3
Advertisement
Table of Contents
