Danfoss MCA 123 POWERLINK Operating Instructions Manual page 23

How to Control the Frequenc...
Bit 12, DSP 402 reserved
Bit 13, DSP 402 reserved
Bit 14, Running/Not running
Bit 14="0" - the motor is not running.
Bit 14="1" - the frequency converter has a valid start signal
or that the output frequency is greater than 0 Hz.
Bit 15, Danfoss reserved
Illustration 5.6 DSP 402 State Machine
MCA 123 POWERLINK Operating Instructions
8-10 Control Profile
Option:
[0]
[7]
FC Profile is the default control profile for the frequency
converter, whereas CANopen DSP 402 is the CiA
standardized control profile, featuring the special DSP 402
transition state machine.
®
MG92C102 - VLT is a registered Danfoss trademark
FC profile
*
CANopen DSP 402
Function:
5 5
21