Problem Solving; No Ethernet Communication On Cgeib-Ip - Crestron CGEIB-IP Operations & Installation Manual

KNX Control Interface

Problem Solving

22  KNX/EIB Control Interface: Crestron CGEIB-IP

No Ethernet communication on CGEIB-IP

Recently we have been working with the manufacturer of the CGEIB-IP to include a
more Crestron friendly web interface. This web interface will make it possible to set
up your CGEIB-IP with group addresses by using only your web browser. That way,
there will be no need to connect to your CGEIB-IP with the KNX-Gate software.
Since our older CGEIB was completely sold out, we already released the CGEIB-IP
with the original web interface. This web interface can be used to set up the TCP-IP
communication with the CGEIB-IP, but does not allow you to set up the device with
group addresses. You'd still need to use KNX-Gate to set the group addresses via RS-
232.
Now, there has been a wrong shipment of CGEIB-IP's that included a beta version of
our new Crestron friendly web interface. You will not be able to connect to these
CGEIB-IP's via TCP-IP. We will describe how to roll back to the original web
interface and set it up for TCP-IP communication.
Note that the CGEIB-IP has two separate firmwares. One firmware defines the web
interface; the other defines the Crestron communication. This document describes
how to roll back the web firmware to the original web interface. The Crestron
firmware still needs to be 7.03 and can be uploaded with the latest KNX-Gate
software.
Crestron CGEIB-IP
Operations & Installation Guide – DOC. 0009