Crestron CGEIB-IP Operations & Installation Manual page 19

Crestron CGEIB-IP
Operations & Installation Guide – DOC. 0009
Use KNX Gate to do the following
 Insert Group Addresses and their corresponding data type
 Change the CGEIB-IP baud rate: 9600 or 38400
 Set KNX transmission settings (Telegrams per second, Transmission limits)
 Import ETS3 project files
 Import .egt data from an older CGEIB-IP configuration
 Export tables in ETS-CSV format to allow import in the ETS. This simplifies the
creation of filter tables.
 Download the last loaded filter table from the CGEIB-IP with the option "Start
reconstruction"
 Set CGEIB-IP communication parameters like: "Transmit for received data" and
"Acknowledge for transmit"
Communication parameters
Under "Setup → Gateway setup" you can change the following options:
 Transmit for received data on KNX:
The Crestron controller will automatically receive data from the KNX units when
their values change.
Example: KNX Group Address 0/0/1 changes the value from 0 to 1 – this information
will then be transmitted to the Crestron controller. It is advised to have this "always
activated".
 Acknowledge for transmit on KNX:
The Crestron controller receives a confirmation from the transmitted telegram, when
this changed the setting in the KNX bus unit.
KNX Control Interface
KNX/EIB Control Interface: Crestron CGEIB-IP  11