Crestron CGEIB-IP Operations & Installation Manual page 11

Crestron CGEIB-IP
Operations & Installation Guide – DOC. 0009
Connectors, Controls & Indicators
# CONNECTORS,
CONTROLS &
INDICATORS
1 KNX/RX/TX LED
2 IP/RS232 LED
3 Power LED
4 RS232 Connector
5 RJ-45 Connector
6 KNX BUS Connector
7 Power Connector
8 KNX Programming-LED
9 Programming button
KNX Control Interface
DESCRIPTION
Color: red/green
Red upon KNX data received, green upon
KNX data transmitted.
Color: red
Red with RS232 connected (DTR=High),
green with IP connected.
Color: blue
Blue if operating voltage is applied.
DB9 female, bidirectional RS232 port
RJ-45 Socket
Wago connector that connects the CGEIB-IP
with the KNX bus.
Wago connector used to power the CGEIB-
IP. The CGEIB-IP should be powered with
24V AC/DC
Color: red
Red when CGEIB-IP is in ETS programming
mode.
Press to set the unit in ETS programming
mode.
KNX/EIB Control Interface: Crestron CGEIB-IP  3