Crestron CGEIB-IP Operations & Installation Manual page 18

KNX Control Interface
10  KNX/EIB Control Interface: Crestron CGEIB-IP
The possible values of the "dual" group addresses are: HG/UG
 HG: 0..15
 UG: 0..2047
o
Inserting Group Addresses in the CGEIB-IP
Once it is clear which Group Addresses and data types are required they have to be
inserted in the CGEIB-IP. The CGEIB-IP uses an internal comparison table with the
required addresses, so it will only pass through the telegrams from and to the bus
when the Group Addresses that are listed in the table. Therefore it is required to insert
all the used addresses in the Crestron CGEIB-IP with the help of the configuration
software, KNX-Gate. To make this easier it is best to create a data file containing all
relevant information. Alternatively you can import the ETS configuration in CSV
format (export file) straight into the CGEIB-IP. It is also possible to transfer an old
project, in EGT format, from a previous CGEIB-IP configuration.
If you need more information to import ETS files, please type "F1 → Functions →
Import and export file" in the KNX-Gate software for further information.
The list will be sent from the PC to the CGEIB-IP over a direct serial connection. The
RS-232 cable must be a "full" cable – all pins connected!
Please be careful with the option "Value request on restart". After a reset Group
Addresses marked as such will automatically be asked for their current status which
on its turn will increase the bus traffic. This however only is the case when the
CGEIB-IP is set to have no transmission limits (more info in this document). All
parameters/setting should be discussed with the KNX programmer.
When you experience problems during the upload of software or firmware,
temporarily disconnecting the KNX bus will help.
Crestron CGEIB-IP
Operations & Installation Guide – DOC. 0009