Installation - Taylor C801 Operating Instructions Manual

CAUTION: THIS EQUIPMENT MUST BE
PROPERLY GROUNDED! FAILURE TO DO SO
CAN RESULT IN SEVERE PERSONAL INJURY
FROM ELECTRICAL SHOCK!
This unit is provided with an equipotential
grounding lug that is to be properly attached to the
rear of the frame by the authorized installer. The
installation location is marked by the equipotential
bonding symbol (5021 of IEC 60417-1) on both the
removable panel and the equipments frame.
S
Stationary appliances which are not
equipped with a power cord and a plug or
another device to disconnect the appliance
from the power source must have an all-pole
disconnecting device with a contact gap of
at least 3mm installed in the external

installation.

S
Appliances that are permanently connected
to fixed wiring and for which leakage
currents may exceed 10 mA, particularly
when disconnected or not used for long
periods, or during initial installation, shall
have protective devices such as a GFI, to
protect against the leakage of current,
installed by the authorized personnel to the
local codes.
S
Supply cords used with this unit shall be
oil-resistant, sheathed flexible cable not
lighter than ordinary polychloroprene or
other equivalent synthetic
elastomer-sheathed cord (Code designation
60245 IEC 57) installed with the proper cord
anchorage to relieve conductors from strain,
including twisting, at the terminals and
protect the insulation of the conductors from
abrasion.
To the Installer
Installation
These machines are designed for indoor use
only.
The C801 grill and the C801 Reverse grill must be
lifted and positioned in place with the aid of a lift
device. They are suspended between the adjacent
sandwich counter and the meat well.
The F802,C803, C803 Reverse, and C804 grills are
mounted on carts. They are wheeled into position in
the store.
The P802 grill is installed into the sandwich counter.
The items to be installed / connected by the
distributor include:
S
Node board modules
S
Lane dividers
S
Miscellaneous accessory brackets
DO NOT install the machine in an area
where a water jet could be used to clean or rinse the
machine. Failure to follow this instruction may result
in serious electrical shock.
This grill must be installed on a level
surface. Failure to comply may result in personal
injury or equipment damage.
2
C801/C801R/F802/P802/C803/C803R/C804