Taylor C801 Operating Instructions Manual page 31

Step 7
Repeat these steps for the remaining platens.
Replace release material sheets if:
S
Release sheet is torn
S
Release sheet is worn
S
Product sticks to the release sheets
Cleaning Platens
Step 1
Wearing vinyl gloves, spray a light layer of DCT
Heavy Duty Degreaser on the platen surface.
Step 2
Using the blue scrub pad, scrub the platen surface
with an up and down motion.
IMPORTANT: Grill screens and Scotch Bricks
must NOT be used to clean the top platens. They
will damage the cooking surfaces.
Step 3
Continue scrubbing until the entire platen grill
surface is clean and no carbon build-up is visible.
Step 4
Clean the sides and top of the platen as necessary.
Step 5
Wipe the platen surface with a damp towel. Rinse
the towel and re-wipe several times to remove any
remaining residue.
Cleaning Platen Release Sheets
Step 1
Wipe the platen sheet using a damp towel. To
remove heavy carbon build-up, spray DCT Heavy
Duty Degreaser on the platen sheet and scrub
thoroughly with a damp towel.
Step 2
Wipe the platen sheet dry and re-install it on the
platen surface.
Note: When re-installing the platen sheet, reverse it
every day to prolong the life of the sheet.
Step 3
Repeat these steps for the remaining platen
release sheets.
C801/C801R/F802/P802/C803/C803R/C804
Reinstall the Platen Release Sheets
Step 1
Lay the sheet out flat on the staging side of the grill.
Step 2
Lay the release sheet bracket on the top edge of the
release sheet with the notches on the bar facing up
and the inside of the angle facing toward you.
Step 3
Fold the end of the sheet in toward the bend of the
release sheet bracket. Center the sheet between the
notches. Place the edge of the sheet flush against
the inside angle.
27
Figure 23
Figure 24
Operating Procedures