Panasonic ELC500 User Manual page 65

[6] System connection
System connection is used to connect a server to the upper device via LAN port.
Item
(a) Protocol
(b) Specify connection use
(c) Communication method
(d) Open method
(Server / Client)
(e) Open method
(Automatically / Manually)
(f) Port No.
(g) IP address *2
(h) Port No.
(i) Disconnect time with no
communication
*1 When it set to 0, it allocate automatically.
*2 Only when 'Server connection (specified)' is selected for open method.
Description
Set communication protocol.
<Initial> MEWTOCOL-COM
<Set range> MEWTOCOL-COM / MEWTOCOL7-COM /
Select use the connection or not.
<Initial> with check = available
Set communication method.
<Initial> TCP/IP
<Set range> TCP/IP / UDP/IP
Set connection open method.
<Initial> Server connection (Any destination)
<Set range> Server connection (Any destination) /
Set connection open method.
<Initial> Automatically
<Set range> Automatically / Manually
Set port number to use by ELC500.
<Initial>
<Set range> UDP/IP: 0 to 65535
Set IP address of the connected device.
*2 Set port number to use by the connected device.
< Set range> 0 to 65535
Set disconnect time during the communication.
Disconnection time exceeds the set time, it will disconnect
automatically.
<Initial> connection 1: 60 sec
<Set range> 1 to 3600
MODBUS TCP / MEWTOCOL-DAT
Server connection (specified)
connection 1: 32769
connection 2: 32770
connection 3: 32771
connection 4: 32772
TCP/IP: 1 to 65535
connection2, 3, 4: 3600 sec
57
ELC500 Control unit
(a)
(b)
(c)
(d)
(e)
(f)
(g)
(h)
(i)
*1