Panasonic ELC500 User Manual page 23

(11) SD memory card slot
Open SD memory card cover to insert or remove SD memory card.
After inserting SD memory card, close the cover. If the cover is not closed correctly, it can't access SD
memory card and can't read nor write.
No. Name
11-1
Battery holder
11-2 SD memory card slot
11-3 Card operation switch
11-4 Battery connector
Note
After stop blinking access LED, eject SD memory card.
Be careful to the direction when inserting. If it is wrong, it might break unit and SD memory
card.
(12) Mode switch
It switches the operation of ELC500.
Switch
RUN (Left)
STOP/PROG. (Center)
COPY (Right: momentary)
* You can change RUN mode or STOP/PROG. mode by 'Configurator EL500'. It starts operation with
the mode of switch position when power on again.
(13) Fixing hook
Use to fix the power supply unit (sold separately) to the main unit.
Use to install the battery.
With mounting backup battery, it backup calendar timer and logging
data when power off.
Use to insert SD memory card.
Select ROM operation or SD operation.
By selecting SD operation, it starts operating by SD memory card.
Connect battery. *Note the polarity.
Start operation.
Execute data collecting and logging, demand monitoring and
control, and programs.
Stop operation.
Stop data collecting and logging, demand monitoring and control,
and programs.
Transmit the project saved in the internal RAM ROM1 to ROM2 as
a backup project.
It uses only when transmitting the project.
15
Function
Operation mode
ELC500 Control unit