Table of Contents
Advertisement
Installation Guide Linear Rotary Motors
360°
NTI AG / LinMot
1. Remove the flange bearing..
The flange bearing is dismantled using a fork wrench SW
36.
2. Mount flange base and shaft seal.
First insert the shaft seal into the groove of the flange and
then screw the flange firmly to the front.
3. Insert the brake.
Push the brake into the opening of the brake flange.
4. Fasten the brake flange.
The brake flange with the applied brake can be rotated
360° and positioned as required. Then fasten with 4
hexagonal screws.
Tightening torque: 10 Nm
PR02-52
ENG
Page 17 / 24
Advertisement
Table of Contents
