Mount A Cmf010 Sensor To A Wall Or Pole - Emerson Micro Motion Elite Coriolis Micro Motion Elite Coriolis CMF025 Installation Manual

Mounting
2.5

Mount a CMF010 sensor to a wall or pole

The CMF010 sensor has an optional mounting configuration for use with small or flexible
pipeline. If the pipeline adequately supports the sensor, you can skip this procedure.
1.
2.
3.
16
Locate the optional mounting holes. For sensors with a junction box, the junction
box must be rotated to the side to expose the mounting holes.
Figure 2-9: Optional mounting
A. Two user-supplied 5/16" (M8) bolts
B. Junction box or core processor (junction box shown)
C. Mounting surface
If necessary, install rigid standoffs between the sensor and the mounting surface.
Using two user-supplied 5/16" (M8) bolts (minimum length 2 1/4" [58 mm]), secure
the sensor case to the mounting surface.
A
B
C
Micro Motion ELITE