Changing Password; Managing Firmware - SMC Networks EliteConnect SMCWHSG44-G User Manual

NOTE: When the Router is in Router with Multiple DSL/Cable Connections
mode, connect your first DSL/Cable connection to WAN, the second to LAN 1,
the third to LAN 2, and the fourth to LAN 3. Then, WAN becomes WAN 1,
LAN 1 becomes WAN 2, LAN 2 becomes WAN 3, and LAN 3 becomes WAN 4
when referred to on the Web management pages.
Fig. 45. WAN Port IDs.
TIP: After you have selected the operational mode of the Router, go to the
TCP/IP, Addressing section of the management UI (see Section 2.4.1) to con-
figure the addressing settings of the WAN and LAN interfaces.
NOTE: Since the WAN load-balancing algorithm is based on the "TCP ses-
sion" rather than on the "packet," a TCP session is allocated to a WAN con-
nection at session initialization time. As a result, if there is only one client,
no throughput improvement will be perceived even if there are several WAN
connections. WAN load balancing is for multiple clients to share multiple
WAN connections. All the TCP sessions from the clients are intelligently dis-
tributed to the WAN connections by the built-in NAT server.

2.3.2. Changing Password

Fig. 46. Password.
On this page, you can change the user name and password of the administra-
tor. The administrator can view and modify the configuration of the
SMCWHSG44-G. The new password must be typed twice for confirmation.

2.3.3. Managing Firmware

Fig. 47. Firmware Management Protocol Setting.
Firmware management operations for the Wireless Hotspot Gateway include
firmware upgrade, configuration backup, configuration restore, and configuration
reset. Firmware upgrade, configuration backup, and configuration restore can
be achieved via HTTP or TFTP. The HTTP-based way is suggested because it's
more user friendly. However, due to different behavior of different Web browser
versions, HTTP-based firmware management operations may not work properly
48