SMC Networks EliteConnect SMCWHSG44-G User Manual page 7

EC Conformance Declaration
SMC contact for these products in Europe is:
SMC Networks Spain S.L.,
Edificio Conata II,
Calle Fructuós Gelabert 6-8, 2o, 4a,
08970 - Sant Joan Despí,
Barcelona, Spain.
Signed and dated Copy of the Declaration of Conformity can be found in the
product section of www.smc-europe.com
This RF product complies with R&TTE Directive 99/5/EC. For the evaluation
of the compliance with this Directive, the following standards were applied:
• Electromagnetic compatibility and radio spectrum matters (ERM)
EN300 328-1 (2001-12)
EN300 328-2 (2001-12)
• Electromagnetic Compatibility (EMC) Standard for radio equipment and services
EN301 489-1 V1.4.1 : 2002
EN301 489-17 V1.2.1 : 2002
• Safety Test
EN60950-1 : 2001
The conformity assesment procedure referred to in Article 10 and detailed in
Annex IV of the Directive 1999/5/EC has been followed related to Articles
3.2 with the involvement of the following Notified Body:
BTS-ETZ Certification GmBH, Storkkower Strasser 38c, D-15562,
Reichenwalde B, Berlin, Germany
Identification Mark
Countries of Operation & Conditions of Use in the European Community
This device is intended to be operated in all countries of the European
Community. Requirements for indoor vs. outdoor operation, license requirements
and allowed channels of operation apply in some countries as described below:
Note: The user must use the configuration utility provided with this product
to ensure the channels of operation are in conformance with the spectrum
usage rules for European Community countries as described below.
• This device requires that the user or installer properly enter the current
country of operation in the command line interface as described in the
user guide, before operating this device.
• This device will automatically limit the allowable channels determined by
the current country of operation. Incorrectly entering the country of
operation may result in illegal operation and may cause harmful interference
6