Appendix B.4. Securing Quickserver With Password; Appendix B.5. Factory Reset Instructions; Figure 23: Fs-Gui Passwords Page; Figure 24: Password Recovery Page - SMC Networks FieldServer QuickServer FS-QS-2 F Series Startup Manual

Appendix B.4. Securing QuickServer with Password

Access to the FieldServer can be restricted by enabling a password on the FS-GUI Passwords page –
click Setup and then Passwords in the navigation panel. There are 2 access levels defined by 2 account
names: Admin and User.
•
The Admin account has unrestricted access to the FieldServer.
•
The User account can view FieldServer information but can't make changes or restart the unit.
The password needs to be a minimum of eight characters and is case sensitive. If the password is lost,
click cancel on the password authentication popup window, and e-mail the password recovery token to
smc-support@msasafety.com
will allow access to the FieldServer in order to set a new password.

Appendix B.5. Factory Reset Instructions

For FieldServer factory reset instructions, see
to receive a temporary password from the FieldServer support team. This

Figure 23: FS-GUI Passwords Page

Figure 24: Password Recovery Page

ENOTE - FieldServer Next Gen
Page 33 of 45
QuickServer Start-Up Guide
Recovery.