Connect The Pc To The Ez Gateway; Connecting To The Gateway Via Ethernet; Enable Access Through The Local Browser; Changing The Subnet Of The Connected Pc - SMC Networks FieldServer FS-EZX-MOD-BAC Startup Manual

5

CONNECT THE PC TO THE EZ GATEWAY

5.1

Connecting to the Gateway via Ethernet

First, connect a Cat-5 Ethernet cable (straight through or cross-over) between the local PC and the EZ
Gateway.

5.1.1 Enable Access Through the Local Browser

There are two methods to enable access to the EZ Gateway in the local browser, either by
changing the subnet of the connected PC (Section 5.1.1.1) or using the FieldServer Toolbox to
change the IP Address of the EZ Gateway (Section 5.1.1.2).
NOTE: Only perform one method or the other.

5.1.1.1 Changing the Subnet of the Connected PC

The default IP Address for the EZ Gateway is 192.168.2.101, Subnet Mask is 255.255.255.0. If the PC
and EZ Gateway are on different IP networks, assign a static IP Address to the PC on the 192.168.1.xxx
network.
For Windows 10:
•
Find the search field in the local computer's taskbar (usually to the right of the windows icon
and type in "Control Panel".
•
Click "Control Panel", click "Network and Internet" and then click "Network and Sharing Center".
•
Click "Change adapter settings" on the left side of the window.
•
Right-click on "Local Area Connection" and select "Properties" from the dropdown menu.
•
Highlight
•
Select and enter a static IP Address on the same subnet. For example:
•
Click the Okay button to close the Internet Protocol window and the Close button to close the
Ethernet Properties window.
EZ Gateway Modbus to BACnet Start-up Guide
Ethernet Port

Figure 8: Ethernet Port Location

and then click the Properties button.
Page 12 of 49
)