Table of Contents
Advertisement
Appendix B.5. Securing QuickServer with Password
Access to the FieldServer can be restricted by enabling a password on the FS-GUI Passwords page –
click Setup and then Passwords in the navigation panel. There are 2 access levels defined by 2 account
names: Admin and User.
•
The Admin account has unrestricted access to the FieldServer.
•
The User account can view any FieldServer information but cannot make any changes or restart
the FieldServer.
The password needs to be a minimum of eight characters and is case sensitive.
If the password is lost, click cancel on the password authentication popup window, and e-mail the
password recovery token to
Monitor support team. This will allow access to the FieldServer in order to set a new password.
Appendix B.6. Factory Reset Instructions
For instructions on how to reset a FieldServer back to its factory released state, see
Next Gen
Recovery.
support@sierramonitor.com
Figure 16: FS-GUI Passwords Page
Figure 17: Password Recovery Page
Page 30 of 34
QuickServer Start-Up Guide
to receive a temporary password from the Sierra
ENOTE - FieldServer
Advertisement
Table of Contents
