Setting Up Mactalk For Ethernet - JVL MAC00-EC41 User Manual

10.3

Setting up MacTalk for Ethernet

10.3.1 Setting up MacTalk for Ethernet communication
When MacTalk is opened the first time it is, by default configured for running serial
RS232/RS485 connection. To change this please find the address box next to the "COM
scan" in the upper tool bar and change it from "All" to "Eth".
Step 1.
Select the Ethernet port used for communication to the PLC/motors as shown below.
TT3074-01GB
Step 2.
After changing the the Address box, the IP-address input field appears.
TT3075-01GB
Step 3.
Now MacTalk is ready to connect to the motor and the next step is to enter the IP ad-
dress of the motor to connect to.
JVL Industri Elektronik A/S - User Manual - Ethernet for MAC and MIS motors
The IP-address field is now shown
249