Commissioning - JVL MAC00-EC41 User Manual

5.3
5.3.1 Indicator LED's - description.
The LED's are used for indicating states and faults of module. There is one power LED,
two link/activity LED's (one for each Ethernet connector), and 2 status LED's.
MAC Module Indicators
and label overview
General status
indicator
Line activity
indicators
TT3045-02GB
LED indicator descriptions - Covers both MAC and MIS/MIL.
LED Text
MAC / MIx
L/A IN /
L2
L/A OUT /
L3
STATUS /
L1
ERROR /
ERR
PWR
Notes:
Blinking: Flashing with equal on and off periods of 200ms (2.5Hz). Single flash: Repeating on for 200ms and
off for 1s. Double flash: Two flashes with a period of 200ms followed by 1s off period. Triple flash: Two flash-
es with a period of 200ms followed by 1s off period.Flickering: Rapid flashing with a period of approximately
50ms (10 Hz).
JVL Industri Elektronik A/S - User Manual - Ethernet for MAC and MIS motors

Commissioning

Error indicator
Power
indicator
MAC address
Hardware serial number
Colour Constant Constant
off
No valid Ethernet
Green Ethernet is
connection. connected.
No valid Ethernet
Green Ethernet is
connection. connected.
NMT_CS_-
NMT_CS_N
Green OPERA-
OT_ACTIVE
TIONAL
Red No error Error
Power is
applied to
Power is not
Green both motor
applied.
and mod-
ule.
MIS Motor Indicators
and label overview
Hardware serial number
Blinking Single
on flash
- -
- -
NMT_CS
NMT_CS
_PREOP-
_STOPP
ERA-
ED
TIONAL1
Power indicator
Error indicator
General status indicator
Line activity indicator (CN2)
Line activity indicator (CN3)
MAC address
(placed at front)
Double Triple Flickering
flash flash
Activity on
- -
line
Activity on
- -
line
NMT_CS NMT_CS
NMT_CS_B
_PREOP- _READY
ASIC_ETH-
ERA- _TO_OP-
ERNET
TIONAL2 ERATE
Booting
error
Power is
applied to
module but
no communi-
cation with
motor.
121