3
Check the Monitor Button and Stop
Monitoring Button on the toolbar of
the Sysmac Studio to see if the
Controller is in monitor status.
Check that the Monitor Button is
selected and is not selectable and
that the Stop Monitoring Button is
selectable (monitor status) as
shown in the right figure.
*If the Controller is not in monitor
status, select Monitor from the
Controller Menu of the Sysmac
Studio.
*If the Sysmac Studio is offline, go
online by following steps 4 to 7 of
7.3.1.
4
Select Watch Tab Page from the
View Menu.
5
The Watch Window (Controller) Tab
Page is displayed in the lower
section of the Edit Pane.
6
Click the cell that states Input Name
at the bottom of the Watch Tab
Page.
7. Connection Procedure
Monitor
Stop Monitoring
26